Advantech MIC-5332 Bedienungsanleitung PDF herunterladen (Seite 115)

4 = Channel 2 is the only allowed port, always use it, never change to channel 1.

The NC-SI LAN controller channel setting will be stored permanently (non-volatile

EEPROM). The default value is 0.

Read LAN channel selection priority:

Response:

Change LAN channel selection priority:

Response:

A.2.3 FPGA COM port UART MUX

MIC-5332 implements several serial interfaces, which can be configured in some

ways. This is done inside the FPGA with the help of an UART MUX (refer to chapter

<x.x.x – UART MUX>). The BMC provides OEM commands to configure these UARTs

via IPMI. Following COM1 / COM2 port settings are available (Caution: Verify note

below about the UART dependency!):

COM interfaces:

Port Interface

0x00 COM1

0x01 COM2

Table 1: COM interfaces

COM1 MUX:

Setting Connection

0x00 no interface connected, open

0x01 Serial-over-LAN (SOL)

39 28 00

ipmitool raw 0x2e 0x40 0x39 0x28 0x00 0x04 0x01 <setting>

39 28 00 <setting>

ipmitool raw 0x2e 0x41 0x39 0x28 0x00 0x04 0x01

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 128 129

Keine Kommentare

Advantech MIC-5332 Bedienungsanleitung Seite 115