Advantech SSPB-3000C Spezifikationen PDF herunterladen (Seite 29)

SSBP-3000C

Page 28

d. Connect the AC power cable to AC Line port of the SSPB and the AC power source.

TABLE 9: POWER REQUIREMENTS

Power Requirements 180 - 264 VAC, 47-63 Hz, single phase

Power Consumption 8 A typical @ 230 VAC

TABLE 10: AC LINE (J5) CONNECTOR – PIN ASSIGNMENTS

Pin Description

A PHASE (LIVE)

B GROUND

C NEUTRAL

5.3.4 RF CONNECTIONS

1. Attach the interconnecting cable with a N-type male connector from the RF source on to the L-

Band IN connector (J1) located on the rear panel (see Figure 5 at page 24).

2. If necessary, connect a power meter or a spectral analyser to the RF output monitor port

located on the front panel (see Figure 5 at page 24).

CAUTION: Ensure that the p

roper pin is selected for AC operation. Applying power on the

wrong pin may permanently damage the SSPB, necessitating factory repair.

CAUTION:

Beware of the destructive pin depth of the mating connector. When installing an

RF mating connector with a de

structive pin depth into an RF component connector, damage

may occur to the RF component connector. A destructive pin depth is a connector having a pin

length that is too long in respect to the reference plane of the connector. The centre pins of the

con

nectors used by ADVANTECH have a precision tolerance measured in mils (1/1000 inch).

The mating connectors of the various suppliers may not be of precision types. Consequently,

the centre pins of these devices may not have the proper depth.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 54 55

Keine Kommentare

Advantech SSPB-3000C Spezifikationen Seite 29