Advantech PCA-6289 Bedienungsanleitung PDF herunterladen (Seite 38)

PCA-6289 User’s Manual 28

2.11 Set Supervisor/User Password

The Supervisor/User Password utility sets the password. The mainboard

is shipped with the password disabled. If you want to change the pass-

word, you must first enter the current password, then at the prompt enter

your new password. The password is case sensitive. You can use up to

eight alphanumeric characters. Press <Enter> after entering the password.

At the next prompt, confirm the new password by retyping it and pressing

<Enter> again. To disable the password, press <Enter> instead of entering

a new password when the Enter Password dialog box appears. A message

appears confirming that the password has been disabled. If you have set

supervisor and user passwords, only the supervisor password allows you

to enter the BIOS Setup Program.

Note: If you forget your password, the only way to solve this problem is

to discharge the CMOS memory by turning power off and placing a shunt

(jumper cap) on jumper JP2 to short pin 2 and pin 3 for five seconds, then

putting the shunt back to pin 1 and pin 2 of JP2.

2.12 Save & Exit Setup

If you select this and press <Enter>, the values entered in the setup utili-

ties will be recorded in the CMOS memory of the chipset. The micropro-

cessor will check this every time you turn your system on and compare

this to what it finds as it checks the system. This record is required for the

system to operate.

2.13 Exit Without Saving

Selecting this option and pressing <Enter> lets you exit the setup program

without recording any new values or changing old ones.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

Keine Kommentare

Advantech PCA-6289 Bedienungsanleitung Seite 38