Advantech EKI-4524I Bedienungsanleitung PDF herunterladen (Seite 21)

2.6 Wiring Relay Alarm Contacts

The fail-safe relay alarm contacts are labeled as 8 and 10 as the figure shown below. With a Normally

Close circuit formed by wiring with an external power and an alarm device (a buzzer or a flashing LED),

system will detect the power failure event. If a failure event occurs, the relay inside EKI-4524I will act as

an open switch, and therefore break the external circuit. The fail-safe design is intended for triggering the

connected alarm device for warning purposes.

20mA@250VDC

P-Fail

Figure 2.5: Fail-Safe Relay Contacts

Note

• Use Copper Conductors Only, 60/75

C, tightening to 5 lb-in

• The wire gauge for the terminal block should be in the range between

12~ 24 AWG.

13 Chapter2

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Advantech EKI-4524I Bedienungsanleitung Seite 21