Advantech IPC-5120 Bedienungsanleitung PDF herunterladen (Seite 30)

IPC-7120 User Manual 22

3.2 Replacing the Cooling Fan

There are two cooling fans that provide good airflow inside the IPC-7120

(IPC-5120). To replace these fans, proceed as follows:

3.2.1 Replacing the 12 cm system fan

1. Remove the chassis top cover and the disk drive housing.

2. Take out the filter first.

3. Disconnect the cooling fan power connector.

4. Loosen the four screws from outside the rear plate and then gently

remove the fan module. Loosen four screws on the fan bracket and

the four screws on the rear side of the module (not the screws on

the fan) and replace it with a new fan. (see Figure 3.3)

5. Attach the new cooling fan on the bracket by screwing in the four

screws.

6. Reattach the fan power connector.

7. Replace the fan module into the chassis and then screw the four

screws onto the rear of the chassis.

Figure 3.3: Replacing the 12 cm fan

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Keine Kommentare

Advantech IPC-5120 Bedienungsanleitung Seite 30