Advantech POC-176 Bedienungsanleitung

POC-175Point-of-Care Terminal with 17" TFT LCDUser Manual

POC-175 User Manual x5.2 Installation of Touchscreen Drivers ... 375.2.1 Installation for Windows XP ...

2CHAPTER 1General InformationThis chapter gives an overview of the POC-175.Sections include:• Introduction• Specifications• Cleaning/Disinfecting•

POC-175 User Manual 2Chapter 1 General Information1.1 IntroductionThe POC-175 is a multimedia Pentium® Mobile processor-based com-puter that is desi

3 Chapter 1 – BIOS: Award 512 KB Flash BIOS, supports Plug & Play and APM– Chipset: Intel® 915GM GMCH, 82801FBM (ICH6-M)– Front side Bus: FSB 533

POC-175 User Manual 4• Internal Speaker: 1 W speaker x 2, Full alarm volume > 70 dB (A) at 1 meter1.2.5 Ethernet interface• Chipset: Marvell 88E805

5 Chapter 1 1.2.8 Environment• Temperature: 0 ~ 40° C (32 ~ 104° F)• Relative humidity: – operating 10 ~ 40° C / 20 ~ 90% RH – Storage -20 ~ 50 °C /

POC-175 User Manual 61.3 Cleaning/DisinfectingDuring normal use of the POC-175 may become soiled and should, there-fore, be cleaned regularly. Agents

7 Chapter 1 1.5 DimensionsFigure 1.1: Dimensions of the POC-175

POC-175 User Manual 8

2CHAPTER 2System SetupThis chapter gives hardware and sys-tem software installation information.Sections include:• A Quick Tour of the POC-175• Inst

POC-175 User Manual iiCopyrightThis document is copyrighted, © 2006. All rights are reserved. The origi-nal manufacturer reserves the right to make im

POC-175 User Manual 10Chapter 2 System Setup2.1 A Quick Tour of the POC-175Before you start to set up the POC-175, take a moment to become famil-iar

11 Chapter 2 When you look at the left side of the POC-175, you will see the CD-ROM drive, two USB2.0 ports and two IEEE1394a port, as shown in Figur

POC-175 User Manual 12Figure 2.3: Rear view of the Point of Care Terminal1 Functional Earth Ground Connector2 Isolated RS-232 COM Ports (COM1/COM2/COM

13 Chapter 2 2.2 Installation Procedures2.2.1 Connecting the power cord Be sure to always handle the power cords by holding the plug ends only.Follo

POC-175 User Manual 142.2.2 Connecting the keyboard and mouse1. Connect the Y-shaped adapter to the PS/2 mouse and keyboard port on the I/O section of

15 Chapter 2 2.3 Running the BIOS Setup ProgramYour POC-175 is likely to have been properly set up and configured by your dealer prior to delivery.

POC-175 User Manual 16If you are presented with the opening screen of a setup or installation pro-gram, follow the instructions on screen. The setup p

17 Chapter 2 The standard procedures for installing the SVGA, audio, touchscreen and Ethernet drivers are described in Chapters 3, 4, 5 and 7 respect

POC-175 User Manual 18

2CHAPTER 3Graphic chipset SetupThis chapter gives details of graphics chipset setup.Sections include:• Introduction• Installation of Graphic Driver•

iiiFCC Class BThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.Th

POC-175 User Manual 20Chapter 3 Graphic chipset Setup3.1 IntroductionThe POC-175 has an onboard VGA interface. The specifications and fea-tures are

21 Chapter 3 3.2.1 Installation for Windows XP1. Click the 'Start' button in the task bar, click 'Run' and then select 'infi

POC-175 User Manual 222. Click 'Next' to continue.

23 Chapter 3 3. Read the license agreement, then click ‘Yes’ to proceed.

POC-175 User Manual 244. When the 'Setup COMPLETE' message appears click 'Finish' to restart your computer.

25 Chapter 3 1. Click the 'Start' button in the task bar, click 'Run' and then select ‘Setup.exe’ from the drive directory “D:\VG

POC-175 User Manual 263. Read the license agreement, then click ‘Yes’ to proceed.

27 Chapter 3 4. When the 'Setup COMPLETE' message appears, click 'Finish' to restart your computer.

POC-175 User Manual 28

29 Chapter 3 3.3 Further informationFor further information about the VGA installation in your POC-175, including driver updates, troubleshooting gu

POC-175 User Manual ivPacking ListBefore installing your Point of Care Terminal, ensure that the following materials have been received:• POC-175 seri

POC-175 User Manual 30

2CHAPTER 4Audio InterfaceThis chapter gives details of audio interface setup.Sections include:• Introduction• Installation of Audio Driver• Further

POC-175 User Manual 32Chapter 4 Audio Interface4.1 IntroductionThe POC-175's onboard audio interface provides high-quality stereo sound and FM

33 Chapter 4 4.2.1 Installation for Windows 2000/XP1. Click the 'Start' button in the task bar, click 'Run' and then select &apos

POC-175 User Manual 343. Click 'Next' to continue. 4. When the 'Setup COMPLETE' message appears click 'Finish' to resta

2CHAPTER 5Touchscreen InterfaceThis chapter gives details of touch-screen interface setup.Sections include:• Introduction• Installation of Touchscre

POC-175 User Manual 36Chapter 5 Touchscreen Interface5.1 Introduction5.1.1 General InformationThe POC-175's optional touchscreen incorporates a

37 Chapter 5 – Mineral spirits– Foods and beverages5.2 Installation of Touchscreen DriversTo facilitate installation of the touchscreen driver, you

POC-175 User Manual 382. Click 'Ok' to continue.

39 Chapter 5 3. Click 'Unzip' to continue.

v• This equipment is a source of electromagnetic waves. Before use please, make sure that there are no EMI sensitive devices nearby which may malfunct

POC-175 User Manual 404. Click 'Ok' to continue.

41 Chapter 5 5. Click 'Next' to continue.

POC-175 User Manual 426. Read the license agreement and click ‘Yes’ to proceed.

43 Chapter 5 7. Click 'Next' to continue.

POC-175 User Manual 448. Click 'Next' to continue.

45 Chapter 5 9. Click 'Next' to continue.

POC-175 User Manual 4610. When the 'Setup COMPLETE' message appears, click 'Finish' and follow the on-screen instructions to compl

47 Chapter 5 5.3 Further InformationFor further information about the Touchscreen installation in your POC-175, including driver updates, troublesho

POC-175 User Manual 48

2CHAPTER 6PCI Express Ethernet InterfaceThis chapter gives details of Ethernet interface setup.Sections include:• Introduction• Installation of Ethe

POC-175 User Manual vi7. The openings on the enclosure are for air convection. Protect the equipment from overheating. DO NOT COVER THE OPENINGS.8. Ma

POC-175 User Manual 50Chapter 6 PCI Express Ethernet Inter-face6.1 IntroductionThe POC-175 is equipped with a high performance PCIe Ethernet chipset

51 Chapter 6 3. Click 'Next' to continue.

POC-175 User Manual 524. When the 'Setup COMPLETE' message appears, click 'Finish' to restart your computer. 6.3 Further Informat

2 APPENDIX AConnector PinoutsThis appendix gives details of connec-tor pinouts.Sections include:• ATX Power Connector• Inverter Power Connector•

POC-175 User Manual 54Appendix A Connector PinoutsA.1 ATX Power ConnectorFigure A.1: POC-175 ATX power connectorTable A.1: ATX power connector (CN37

55 Appendix A A.2 Inverter Power Connector Figure A.2: POC-175 Inverter power connectorTable A.2: Inverter power connector (CN3)15 GND16 GND17 GND18

POC-175 User Manual 56A.3 Internal Speaker Connector Figure A.3: POC-175 Internal speaker connectorTable A.3: Internal speaker connector (CN26)A.4 F

57 Appendix A Table A.4: Power connector (J4)Table A.5: Reset connector (J3)A.5 IR Connector (*Reserved)Figure A.5: POC-175 IR connectorTable A.6: I

POC-175 User Manual 58A.6 EIDE HDD Connector (Primary/Master)Figure A.6: POC-175 EIDE hard disk connectorTable A.7: EIDE hard disk connector (CN10)Pi

59 Appendix A # Low activeA.7 CD-ROM Connector (Primary/Slave)Table A.8: CD-ROM connector (CN7)15 DATA116 DATA1417 DATA018 DATA1519 SIGNAL GND20 NC2

vii17. IMPROPER INSTALLATION OF VESA MOUNTING CAN RESULT IN SERIOUS PERSONAL INJURY! VESA mount installation should be carried out by a professional t

POC-175 User Manual 601 Audio_L2 Audio_R3GND4GND5 IDE RESET #6DATA87DATA78DATA99DATA610 DATA1011 DATA512 DATA1113 DATA414 DATA1215 DATA316 DATA1317 DA

61 Appendix A A.8 CPU Fan Power Connector Figure A.7: POC-175 CPU fan connector Table A.9: CPU fan power connector (CN19)39 GND40 GNDPin No. Signal

POC-175 User Manual 62A.9 System Fan Power ConnectorFigure A.8: POC-175 System fan connector Table A.10: System fan power connector (CN39)A.10 PCI B

63 Appendix A A.11 CPU Selection Connector (SW1 & SW2)Table A.11: (SW1)Table A.12: Table A-12: (SW2)Note This PCI slot uses standard PCI Bus V2.

POC-175 User Manual 64A.12 COM2Figure A.10: POC-175 COM2 connectorTable A.13: COM2 pin assignmentConfigure Signal DescriptionPin No. RS-232 RS-422 RS

65 Appendix A A.13 Locating connectors Figure A.11: Locating connectors on the POC-175 motherboardHHGGFFEE01-3MADE IN TAIWAN19C6969002PCM-9690 REV.A

POC-175 User Manual 66

2 APPENDIX BJumper Setting and ConnectorsThis appendix describes jumper set-tings.Sections include:• Jumpers and connectors• CPU’s Configurati

POC-175 User Manual 68Appendix B Jumper Setting and Con-nectorsB.1 Jumpers and connectorsB.1.1 Setting jumpersYou can configure your Point of Care T

69 Appendix B B.1.2 Jumpers and switchesThe motherboard of the Point of Care Terminal has a number of jumpers that allow you to configure your system

POC-175 User Manual viii24. This equipment shall not be used in life support systems.25. Accessory equipment connected to the analog and digital inter

POC-175 User Manual 70B.2 CPU ConfigurationYou can install an Intel® Pentium® Mobile or Celeron™ Mobile CPU. For detailed information, please see App

71 Appendix B B.3.1 COM2 Output Type Setting (JP9)COM2 can be configured to operate in RS-232, RS-422, or RS-485 mode. This is done via JP9. JP9 is t

POC-175 User Manual 72However, if you wish to disable the port or change these parameters later you can do this in the system BIOS setup. The table ov

73 Appendix B Table B.4: COM Port Pin9 Output Type Configuring (JP5/JP6/JP7/JP8)* This function is for JP8 only.B.4 Watchdog Timer ConfigurationAn o

POC-175 User Manual 74

2 APPENDIX CHardware InstallationThis appendix describes hardware installation.Sections include:• Overview of Hardware Installation and Upgradi

POC-175 User Manual 76Appendix C Hardware InstallationC.1 Overview of Hardware Installation and UpgradingThe Point of Care Terminal consists of a PC

77 Appendix C C.2 Disassembling the Panel PCThe following are standard procedures for disassembling the Point of Care Terminal before you upgrade yo

POC-175 User Manual 78C.3 Installing the 2.5" Hard disk drive (HDD)You can attach one enhanced Integrated Device Electronics (IDE) hard disk dri

79 Appendix C C.4 Installing the Central Processing Unit (CPU)The Point of Care Terminal's central processing unit (CPU) can be upgraded to imp

ixContentsChapter 1 General Information ... 21.1 Introduction ...

POC-175 User Manual 807. Slide the CPU in gently, and make sure the pins of the CPU corre-spond with the holes of the socket. DO NOT USE EXCESSIVE FOR

2 APPENDIX DProgramming the Watchdog TimerThis appendix describes programming the watchdog timer.Sections include:• Programming the Watchdog Ti

POC-175 User Manual 82Appendix D Programming the Watchdog Timer To program the watchdog timer, you must write a program which writes I/O port address

83 Appendix D The following example shows how you might program the watchdog timer in BASIC:Figure D.1: Watchdog programming example in Basic Languag

POC-175 User Manual 84

2 APPENDIX EVESA MountingThis appendix describes VESA mount-ing.

POC-175 User Manual 86Appendix E VESA MountingThe POC-175 also provides standard VESA mounting to help system integrators conveniently integrate the

87 Appendix E Figure E.1: VESA mounting dimension diagram (75 x 75 mm, 100 x 100 mm)

POC-175 User Manual 88