Advantech PWS-1409 Bedienungsanleitung PDF herunterladen (Seite 18)

PWS-1409/1419 User’s Manual

2-3 Removing the CD ROM cage

Step 1. Remove screws as shown (1) and then pull out

the CD ROM Upper cage.

Step 2. Remove screw as shown (2) and then pull out

the CD ROM Bottom cage.

2-4 Removing the hard drive and slim

floppy Drive cage

Lay the chassis on your work area so that you have

access to the bottom side.

Remove the 4 screws and take out the cage.

After you removed the slim CD ROM cage and Drives cage from the chassis, set them aside.

Your are now ready either to install the drives in the drive cage or install the backplane.

2-5 Installing The Backplane

Make sure that at no time you are working on any electrical or electronic components while any

part of the system is energized. Always disconnect the power! Use caution to protect the

delicate electronic components. Ground your self during the installation of the motherboard

and other components.

2-6 Installing the Standoffs

#9 Standoffs

#2 3x4 screws to tighten backplane

#4 Washer between the backplane and screws

Take a moment to study the inside of the chassis, making note of the location of the keyboard

Connector if it come with backplane.

Step 1. Slant the backplane retention into the chassis and position it in the area it will be

installed, making sure the alignment of the slots and connectors is correct.

Step 2. Make sure the location of the backplane mounting points. You are going to install

standoffs at those mounting points.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Keine Kommentare

Advantech PWS-1409 Bedienungsanleitung Seite 18