Advantech PCM-5864L Bedienungsanleitung PDF herunterladen (Seite 33)

Chapter 2 Installation 21

2.7 Installing system memory (DIMMs)

You are able to install memory ranging from 8 to 128 MB of

DIMM onto your PCM-5864/5L card. The card provides one

168-pin DIMM socket, which accepts 8, 16, 32, 64 or 128 MB

3.3 V power level EDO/synchronous DIMMs.

2.7.1 Installing DIMMs

The procedure for installing DIMMs is described below. Please

follow these steps carefully. The number of pins are different on

either side of the breaks, so the module can only fit in one way.

DIMM modiles have different pin contacts on each side, and

therefore have a higher pin density.

1. Make sure that the two handles of the DIMM socket are in the

“open” position. i.e. The handles remain leaning outward.

2. Slowly slide the DIMM module along the plastic guides on

both ends of the socket.

3. Press the DIMM module right down into the socket, until you

hear a click. This is when the two handles have automatically

locked the memory module into the correct position of the

socket.

To remove the memory module, just push both handles outward,

and the module will be ejected from the socket.

2.8 IDE hard drive connector (CN12)

You can attach one or two Enhanced Integrated Device

Electronics hard disk drives to the PCM-5864/E/L’s internal

controller. The PCM-5864/E/L’s IDE controller uses a PCI local-

bus interface. This advanced IDE controller supports faster data

transfer, PID mode 3, and mode 4.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 140 141

Keine Kommentare

Advantech PCM-5864L Bedienungsanleitung Seite 33