Advantech AIMB-766 Bedienungsanleitung PDF herunterladen (Seite 17)

9 IPC-630 User Manual

Chapter 2 System Setup

2.3 Installing CPU Card or Add-on Card

IPC-630 supports up to 15 add-on cards. To install a CPU card or add-on card,

please proceed as follows:

1. Select a vacant PICMG slot for the full-length CPU card, or a PCI/ISA slot for

other add-on cards. Then, remove the corresponding I/O bracket attached to the

rear plate of the chassis.

2. Insert the CPU card (with CPU, CPU cooler, RAM, and necessary cables

installed) or add-on card vertically into the proper slot (See Figure 2.5). For full-

length cards, please make sure that the card bracket has been inserted properly

and the other edge of the card has been inserted into the plastic guiding fillister.

Fasten the card with the screw on top of the I/O bracket.

3. Repeat Step 1 and 2 if there is more than one add-on card to be installed.

4. Connect the 9-pin USB wire, PS/2 wire, power switch wire and the System

Reset switch wire from the chassis to the CPU card.

5. Connect the wire of HDD LED from the chassis to the CPU card.

6. For the PICMG1.0 Backplane, connect the orange-white wire from the connec-

tor CN20 on the CPU card to the connector, HCN1, on the backplane. Connect

the 4-pin +12 V power connector from the power supply to the CPU card.

Figure 2.5 Installing a full-length CPU card

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Keine Kommentare

Advantech AIMB-766 Bedienungsanleitung Seite 17